Operations; Basic Operations - Clarion CZ301E Manual De Instrucciones

5. OPERATIONS

Basic Operations

Note:
• Refer to the diagrams in "3. CONTROLS"
when reading this chapter.
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume
raised to the maximum level may harm
your hearings.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [SRC / ] button on the front
panel to turn on the power under standby
mode. The unit goes back to the last
status after power on.
3. Press and hold the [SRC /
the front panel to turn off the power.
CT (Clock Time) display
• The displayed clock data is based on the
CT (clock time) data in the RDS signal.
Volume adjustment
Turn the [VOLUME] knob on the front panel.
The adjustable range of volume is 0 to 40.
While driving, keep the volume level at
which external sounds can be heard.
Playing source selection
Press [SRC /
repeatedly to choose desired playing source.
Notes:
• Playing source selection means selecting
work mode, such as DISC mode, RADIO
mode, AUX mode and BT mode.
Display system time
Press the [ D ] button on the front panel to
switch the display information between RDS
information, system time and playing source.
RESET
Note:
* When the [RESET] button is pressed,
frequencies of radio stations, titles, etc.
stored in memory are cleared.
] button on
CAUTION
] button on the front panel
RESET
8