Würth 1952 003 680 Traducción Del Manual De Instrucciones De Servicio Original página 9

DE
GB
INTRODUCTION FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
DA
- This product should only be used as described in this
documentation; any other use is considered improper.
EL
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
Ball joint extractor.
- Universal
- For cars, vans and small-sized commercial vehicles.
Universal application for thrust heads and transverse rods, as well
as for support joints. Especially suitable for new car models with
multi-link aluminium suspensions where ball joints are often very big
and very close together. Kingpins are often larger than the standard
ball joints.
Examples: VW / Audi, BMW, Mercedes Benz and Porsche.
This SET consists of:
4 Interchangeable forks (sizes: 24, 27, 31, 36 mm)
METHOD OF PREPARATION
1952 003 681 - Fork opening
1952 003 682 - Fork opening
1952 003 683 - Fork opening
1952 003 684 - Fork opening
1952 003 686 - basic body with central adjuster screw for the
forks with a working range of 25-90 mm
1952 003 685 - thrust spindle with dual drive and trapezoidal
thread, also usable with pneumatic gun.
WARNING: operating instructions and safety tips
-
-
-
-
-
-
-
-
-
To prevent serious personal injury, always wear appropriate
safety equipment in accordance with accident prevention
Standards (goggles/protective gloves/safety footwear/hearing
protection, etc.).
Do not exceed the tool's rated capacity, spread or reach.
Use a protective sheath for safety reasons. It will help to protect
you from shards/shivers during removal and also in case the
tool slips.
Do not strike the end of the thrust screw.
When used with an impact tool, use ear protection.
Do not use wrench extensions.
Do not change the tool in any way.
This tool is for professional use only.
Replace worn or damaged parts.
(A) 24 mm
(A)
27 mm
(A)
31 mm
(A)
36 mm
(B)
(A)
(B)
9