Installation Instructions - Vimar ELVOX 6009 Manual Para El Conexionado Y El Uso

Petrarca series monitor Art. 6009 or 6009/C or 6029/C can work in conjunction with interphone Art. 6209 or 62I8
for video door entry systems series Two wires Elvos or Two wires Videokit.
TECHNICAL CHARACTERISTICS OF ART. 6009, 6029
- Wall-mounted monitor with B/W screen, 4" for 6009, 3,5" for 6029
- Video signal standard: CCIR with 625 lines and 50 frames (EIA standard available on request)
- Passband: 4 MHz
TECHNICAL CHARACTERISTICS OF ART. 6009/C, 6029/C
- Wall-mounted monitor with LCD colour screen, 4" for 6009/C, 3,5" for 6029/C
- Video signal standard: PAL

INSTALLATION INSTRUCTIONS

Fix the bracket type 6145 to the wall at a height of approximately 1.4 m above the ground (Fig. 2).
Open the interphone, split the cover from the bottom making pressure on the lower side of the cover (Fig. 3 -
4).
Fit the base of the interphone into the appropriate seats to the left of the bracket. Slide the base of the inter-
phone downwards until it is completely fastened. Connect the wires to the terminals of the interphone and mo-
nitor card (Fig. 5)
Connect the wiring of the monitor to the connection card by means of connector CN1 on the card.
Fit the monitor in the appropriate seats in the bracket. Slide the base of the monitor downwards until it is com-
pletely fastened (Fig. 6).
Close the interphone by hooking the cover onto the base and pressing the bottom of the cover until it clicks shut.
To remove the interphone or monitor from the bracket, press the safety tab with a screwdriver in the direction
of the arrows (Fig. 7).
DESK-TOP CONVERSION KIT FOR MONITOR AND INTERPHONES
Open the interphone, split the cover from the bottom making pressure on the lower side of the cover (Fig. 3, 4).
Fit the base of the interphone into the appropriate seats to the left of the bracket. Slide the base of the inter-
phone downwards until it is completely fastened. Connect the wires to the terminals of the interphone and mo-
nitor card (Fig. 9).
Connect the wiring of the monitor to the connection card by means of connector CN1 on the card.
Fit the monitor in the appropriate seats in the bracket. Slide the base of the monitor downwards until it is com-
pletely fastened (Fig. 9).
Close the interphone by hooking the cover onto the base and pressing the bottom of the cover until it clicks
shut. To remove the interphone or monitor from the bracket, press the safety tab with a screwdriver in the di-
rection of the arrows (Fig. 9).
GB 3