Publicidad
Idiomas disponibles
Idiomas disponibles
DASH DISASSEMBLY
1. Remove (2) 9/32" screws securing the
driver's side knee bolster to the dash.
(Figure A)
2. Slightly pull down on the knee bolster
to expose the 9/32" screws securing the
base of the dashboard trim panel, then
remove the screws. (Figure A)
3. Remove (1) Phillips screw in the
instrument cluster.
4. Unclip and remove the dashboard trim
panel, using caution not to damage the
hazard switch while removing the panel.
5. Remove (2) 9/32" screws securing the
radio. Slide the radio out, then unplug
and remove the radio.
Continue to Kit Preparation
2
(Figure A)
KIT PREPARATION
1. Place the radio trim panel over the
factory dashboard trim panel. (Figure A)
2. Using a scribe tool, score the area in the
radio section to be cut. (Figure B)
3. Remove the radio trim panel, then cut
the scored area with a cutting tool.
Continued on the next page
Mark here
(Figure A)
Remove shaded area
(Figure B)
|
386.257.1187
MetraOnline.com
Publicidad
