Installing Fastt Pak Agent (Option) - Nobles Speed Scrub 2401 Manual Del Operador

OPERATION
7. Align pad driver mounting studs with slots in motor
hub. Give the driver a quick turn toward the motor
hub spring clip. Be certain that spring clip locks
into one of the studs before operating machine
(Figure 9).
FIG. 9
NOTE: Always make sure pad drivers and motor hub
surfaces are always clean before installing drivers.
Clean surfaces will ease pad driver removal later.
8. Close skirt housing and refasten latch.

INSTALLING FaSTt PAK AGENT (OPTION)

Machine must be equipped with the FaSTt Option.
1. Remove the perforated knock-outs from the
FaSTt PAK MP (Multi-purpose) Hard Floor
Concentrate carton. Do not remove the bag from
the carton. Pull out the bag's hose connector at
the bottom of the bag and remove the orange
hose cap from the connector (Figure 10).
ATTENTION: The FaSTtPAK MP Hard Floor
Concentrate is specifically designed for the
FaSTt system scrubbing application. NEVER use
a substitute, machine damage will result.
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
FIG. 10
2. Place the FaSTt PAK carton in the carton holder
at the rear of the machine and connect the supply
hose to the FaSTt PAK bag (Figure 11).
10
Home Find... Go To..
FIG. 11
NOTE: If any dried concentrate is visible on the
supply hose connector or on the FaSTt PAK
connector, soak and clean with warm water.
3. Make sure to connect the supply hose onto the
hose storing plug when not in use (Figure 12).
This will prevent the FaSTt solution system from
drying out and clogging up the supply hose.
FIG. 12
4. The FaSTt solution system MUST be primed for
first time use. To prime system, make sure the
solution tank is empty and operate the machine in
the FaSTt Scrub Mode for 3 minutes (See
MACHINE OPERATION). This step is only
required for first time FaSTt system use.
Speed Scrubt 2401/2601 (07–02)