YATO YT-82902 Manual Original página 11

PRODUCT SPECIFICATION
The cordless ratchet drill is a universal, portable tool which does not require an external power source, designed for DIY enthusi-
asts to screw and unscrew screws and bolts using additional wrenches mounted on the driver. Its specifi c advantages will be ap-
preciated by DIY enthusiasts performing various assembly and fi nishing works. As the proper use of the power tool is a condition
for the correct, reliable and safe operation of it, please
Read and keep the entire manual before the fi rst use of the tool.
The manufacturer shall not be held liable for any damage resulting from failure to observe the safety regulations and recommen-
dations specifi ed in this manual.
ACCESSORIES
The product is supplied complete and does not require assembly. The battery, charging station (charger), driver reducer and
socket wrenches are supplied with the product.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Operating Voltage
Revolutions (idle speed)
Max torque
Noise level
- sound pressure
- power L
wA
Ingress protection rating
Protection class
Vibration level
Weight
Tool holder
Battery type
Battery capacity
Charger
Input voltage
Power frequency
Output voltage
Output current
Rated power
Charging time
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do not
work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours. Elec-
tric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours. Do not allow children
and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock. Avoid
contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk of an
electric shock. Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool
O R I G I N A L
GB
Units
[V]
[min ]
-1
[Nm]
[dB]
[dB]
[m/s ]
2
[kg]
[mm / '']
[Ah]
[V]
[Hz]
[V]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82902
12 DC
0 - 250
45
78.66 ± 3.0
89.66 ± 3.0
IP20
III
2.898 ± 1.5
0.75
10 / 3/8
Li-ion
1.5
100 - 240
50 / 60
12
2
35
1
11