YATO YT-82902 Manual Original página 14

GB
Release the switch and wait for the motor to stop completely.
When unscrewing, make sure that the torque of the nut does not exceed the maximum torque of the tool. In this case, the overload
clutch will also engage and it may not be possible to unscrew the nut.
After unscrewing, release the pressure on the device switch and wait until the motor revolutions stop completely. Then secure the
switch by sliding the locking button towards the battery.
After fi nishing work, disconnect the tool from the power supply and proceed with maintenance.
Illuminating light
The tool is equipped with a lamp to illuminate the workplace. The light switches on automatically when the switch is pressed and
switches off when the switch is released. The lamp may still light up for some time after releasing the pressure on the switch.
Additional notes
Take regular breaks during work.
Do not overload the tool, the temperature of the external surface must never exceed 60 C.
o
After fi nishing work, switch off the tool, disconnect the battery and perform maintenance and inspection.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the way the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
14