Additional Safety Instructions; Protective Equipment; Service And Maintenance; Machine Tools - Atlas Copco COBRA COMBI Instrucciones De Seguridad Y Para El Operario

Cobra Combi & Standard

Additional safety instructions

► Machines and accessories must only be used
for their intended purpose.
► Only qualified and trained persons may operate
or maintain the machine.
► Keep your hand away from the start and stop
device until work is to begin.
► Learn how the machine is switched off in the
event of an emergency.
► The machine should be operated at reduced
power when drilling is started.
► Release the start and stop device in case of
interruption of the energy supply.
► Always inspect the equipment prior to use.
Do not use equipment if you suspect that it
could be damaged.
► Check the insertion tools for wear or damages
at regular intervals. Do not use worn out or
damaged insertion tools.
► Always use your common sense and good
judgment.
► Do not use the machine when you are tired or
under the influence of drugs, alcohol or anything
else that may affect your vision, reactions or
judgement.
► Participate in safety and training courses.
► Never strike or abuse any equipment.
► Keep the machine and tools in a safe and locked
place out of reach of children.
► Make sure that the all attached and related
equipment is properly maintained.
► Signs and stickers that are important for your
safety and the care of the machine are included
with every machine. New signs and stickers can
be ordered using the spare parts list.
© 2005 Atlas Copco Construction Tools AB
www.CrowderSupply.com • Toll Free: 888-883-5144
| |
No 9800 0636 90 2005-09-16
Safety and operating instructions

Protective equipment

Always use approved personal protective
equipment. Operators and other persons in the
work area must wear protective equipment,
including at a minimum:
► Protective helmet
► Hearing protection
► Impact resistant eye protection with side
protection
► Respiratory protection when appropriate
► Protective gloves
► Protective boots

Service and maintenance

Regular maintenance is a prerequisite for keeping
the machine a safe tool. Carefully follow the
operating instructions.
► Use only authorized parts. Any damage or
malfunction caused by the use of unauthorized
parts is not covered by Warranty or Product
Liability.
► Change damaged parts immediately.
► Replace damaged and worn out components in
good time.
► For major service to the machine, contact your
nearest authorized Atlas Copco workshop.
► When cleaning mechanical parts with solvent,
make sure that current health and safety
regulations are complied and that the ventilation
is satisfactory.

Machine tools

► Keep the tools clean and in a good condition.
Check tools regulary and make sure that they
are sharp.
9