Metra 99-6538B Instrucciones De Instalación página 8

• Connect the Yellow RCA jack to the rear-view camera input.
Note: The rear-view camera input is used to display the climate control status and
personalization menu. If the aftermarket radio does not have a screen with a rear-view
camera input, then there will be no visualization of the climate controls status and
personalization menu, which makes adjusting the climate control impossible. An externally
mounted screen could be substituted in this situation.
• Tape off and disregard the following (1) wire, it will not be used in this application: Brown
From the 6538 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the 4-pin Molex harness on the 24-pin connector, to the 4-pin Molex harness on the
52-pin connector (with gray and white wires).
• Disregard the remaining 4-pin Molex harness, it will not be used in this application.
• Disregard the 4-pin harness with stripped leads, it will not be used in this application.
• Tape off and disregard the following (2) wires, they will not be used in this application:
White/Green, White/Red
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
8
CONNECTIONS TO BE MADE
(CONT.)
For vehicles with a factory rear-view camera:
• Keep connected the Yellow male RCA jack, to the Yellow female RCA jack.
This will retain the factory rear-view camera.
For vehicles without a factory rear-view camera:
• Connect the aftermarket rear-view camera to the Yellow female RCA jack.
From the 4-pin black connector:
• Connect the Orange wire, to the Orange wire on the 18-pin harness with
stripped leads.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
|
1.800.221.0932 MetraOnline.com