Note From The Manufacturer; Installation; Recommendations For The Chimney - Carbel I100 Manual De Instrucciones De Uso Y Mantenimiento

1. NOTE FROM THE MANUFACTURER

Thank you for choosing one of our models. Please read this manual carefully. It has been written to give you tips
on installation, use and maintenance. If you need any further clarification, please contact your dealer or the
manufacturer directly.
Our models are designed to improve the performance of any conventional fireplace. The fans circulate the air
inside the convection chamber that surrounds the fireplace. Air enters through the bottom of the front and
comes out hot at the top. Optionally, the hot air can also be blown to the top of the chimney hood and to other
surrounding rooms.
The fireplace interior is made of high-quality steel and, depending on the model, can be covered with pieces of
refractory material, steel panels or plates of vermiculite.
Note: Graphic representations and drawings included in this manual may not correspond exactly with your model.

2. INSTALLATION

All our models are designed and manufactured for optimal performance. However, the operation and
performance you get will depend largely on the installation

2.1 Recommendations for the chimney

Correct operation depends on the chimney draught. Tips for optimal performance:
- The wood burner must be connected to a flue that guarantees sufficient chimney draught (at least 12 Pa).
- The flue must have sufficient height (not less than 4 m) and should extend at least one meter beyond the
maximum height of the building and other surrounding buildings, trees and other obstacles in a minimum
radius of 10 m.
- The diameter of the flue of the appliance is ideal for keeping a good draught; do not reduce said diameter if at
all possible.
- Do not connect several appliances to the same chimney.
- The chimney should run through the interior of the building. Install insulated double-walled pipes when the
chimney flue runs outside the building.
- When the flue has to have angles or bends, avoid horizontal or downward sections. You must plan for the
cleaning of the flue and, if necessary, install pipes with access holes or cleaning hatches in sections that are
not easily accessed.
- When a metal chimney is fitted inside a brick chimney, it must exceed the height of the latter and protrude a
few centimeters at the top.
- The installation of the pipe and cap must strictly prevent water from getting into the appliance on rainy days.
Water causes more damage to wood burners than the high combustion temperatures for which they are
prepared.
.
13