Automatic Boost Function - Cramer 82LM61S Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
WARNING!
EN
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
WARNING!
Always inspect mower for missing or damaged parts and blade
for damage, uneven, or excessive wear prior to use. Using a
product with damaged or missing parts could result in serious
personal injury.
WARNING!
For complete charging instructions, refer to the operator's manual
for the battery packs and chargers listed in the specifications
section.
To Install Battery Pack
1
Lift and hold up the battery door.
2
Align the battery with the mower's battery port.
3
Insert the batteries into the two battery compartments to start the mower.
This mower is equipped with an automatic switch function which allows
the second battery to work when the first battery has run down.
4
Make sure the battery release button snaps in place and that battery is fully
seated and secure in the mower before beginning operation.
5
Insert the safety key.
6
If the machine is not going to be used immediately, do not insert the safety
key.
7
Close the door.
8
cramer.eu
(see Figure 7)
To Remove Battery Pack
1
Release the power lever to stop the product.
2
Open the battery door to access the battery compartment.
3
Remove the safety key.
4
Press the battery release button. This will cause the battery to raise out of
the tool slightly.
5
Remove battery pack from the product.
Starting/Stopping The Mower
1
Press and hold the safety lock-out button.
2
Pull the power lever upward to the handle to start the mower and release
the safety lock-out button.
3
To stop the mower, release the power lever.
NOTE: A high-pitched noise and sparking may occur as the electric motor decel-
erates. This is normal.

Automatic boost function

When the mower encounter high grass the rpm is automatically increased in
order to maintain a good cutting and collecting results. When going back to
normal cutting conditions the rpm automatically goes back to the standard rpm to
save run time.
Self-Propelled Mowing
(see Figure 8)
To engage the self-propelled feature:
1
Start the mower.
2
Pull the self propel lever upward to meet the handle.
To disengage the self-propelled feature:
1
Release the self propel lever.
To adjust the speed of self-propelled feature:
1
Pull the variable speed control lever towards the Rabbit Symbol to increase
(see Figure 7)
(see Figure 8)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2500386

Tabla de contenido