Operation And Maintenance - GRAPHITE 58G214 Manual Del Usuario

LEFT – RIGHT DIRECTION OF ROTATION
Choose direction of spindle rotation with the direction selector switch (5) (fig. F).
Clockwise rotation – set the direction selector switch (5) to the extreme left position.
Counter-clockwise rotation – set the direction selector switch (5) to the extreme right position.
* In certain cases position of the switch related to rotation may be different than specified. Please refer to graphic signs
placed on the switch or tool body.
Safe position of the direction selector switch (5) is in the middle, it prevents accidental starting of the power
tool.
Drill cannot be started, when the switch is in this position.
Use this position of the switch to change drills or bits.
Before starting the tool make sure the position of the direction selector switch (5) is correct.
Do not change direction of rotation when the drill spindle is rotating.
CHANGE OF GEAR
Gear switch (4) (fig. G) allows to increase the range of rotational speed.
Gear I: small speed range, big torque
Gear II: wider speed range, small torque.
Set the gear switch in position appropriate for the works to perform. Turn the spindle slightly if the gear
switch cannot be moved.
Never change the gear switch position when drill is operating. It may damage the power tool.
Long lasting drilling at low rotational speed of the spindle may cause motor overheating. Provide
regular breaks during operation or let the tool operate at maximum speed with no load for
approximately 3 minutes.
MAINTENANCE AND STORING
Cleaning the device after each use is recommended.
Do not use water or any other liquid for cleaning.
Clean the drill with a dry cloth or blow with compressed air at low pressure.
Do not use any cleaning agents or solvents, they may damage plastic parts.
Clean ventilation holes in the motor casing regularly to prevent device overheating.
In case of excessive commutator sparking, have the technical condition of carbon brushes of the motor
checked by a qualified person.
Store the drill in a dry place, beyond reach of children.
QUICK RELEASE CHUCK REPLACEMENT
Quick-release chuck is screwed onto spindle of the drill and additionally secured with a screw.
Set the direction selector switch (5) in the middle position.
Open jaws of quick release chuck (1) and unscrew the fixing screw (left-hand thread) (fig. H).
Install hexagonal key in the quick release chuck and tap the other end of the key.
Unscrew the quick release chuck.
Installation of the quick release chuck is similar to deinstallation, only the sequence of actions is reversed.
All defects should be repaired by service workshop authorized by the manufacturer.

OPERATION AND MAINTENANCE

19