Publicidad
Step 8
Separate a set of EXTENSION SLIDES (35MC) from the EXTENSION
å
RAILS (35MA) as shown in the enlarged diagram below. Be prepared, the
parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the ENDS (A and B). Use four
å
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the END. Turn
a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
Edge with CAM DOWELS
Open end
Page 12
35MC
Edge with CAM DOWELS
3
2
1
B
35MA
1
2
3
A
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
3S
Publicidad
