Important Safety Notices - Volvo Penta 3862101 Instrucciones De Montaje

INTRODUCTION
This installation instruction covers Volvo Penta
equipment manufactured by Volvo Penta to be used
on Volvo Penta products. Any use other than those
specified in these instructions may give unpredict-
able results.
Proper preparation is extremely helpful for efficient
service work. A clean work area at the start of the
job will minimize tools and parts becoming mis-
placed. Obtain tools, instruments and parts needed
for the job before work is started. Interrupting a job
to locate special tools or repair kits is a needless
delay.
SERVICE POLICY
Whether within or following the warranty period,
Volvo Penta has a constant interest in our products.
It is Volvo Penta's policy to provide dealers with
service knowledge so they can give professional
service demanded by today's consumer. Volvo Penta
Service Schools, frequent mailing of Service Bulle-
tins, Letters and Promotions, Special Tools and
these instructions represent Volvo Penta's efforts in
giving consumers the best and most prompt service
possible. If a service question does not appear to be
answered in these instructions, you are invited to call
or write to the Volvo Penta Service Department for
additional help. Always be sure to give complete
information, including engine model and serial
number.
Be sure you are familiar with Volvo Penta's Warranty.
If you have any questions, call or write the V olvo
Penta Service Department. If other than genuine
Volvo Penta parts and components are used, Volvo
Penta may refuse subsequent warranty claims
involving that engine.
When a brand-name product or specific tool is
specified, another item may be used. However, the
substitute must have equivalent characteristics,
including type, strength, and material. It is your
responsibility to determine if incorrect substitution
could result in product malfunction and personal
injury to anyone. To avoid hazards, equivalent
products which are used must meet all U.S. Coast
Guard Safety Regulations and ABYC standards.
4
REFERENCES, ILLUSTRATIONS AND
SPECIFICATIONS
Volvo Penta reserves the right to make changes at
anytime, without notice, to specifications, models,
and procedures. Also, the right to change any
specifications or parts at any time without incurring
any obligation to equip same models manufactured
prior to date of such change. All information,
photographs, illustrations, and specifications,
contained in these instructions are based on the
latest information available at the time of printing.
Photographs and illustrations used in this instruction
may not depict actual models or equipment. The
continuing accuracy of this installation instruction
cannot be guaranteed.
Use the general torque specification for all fasteners
unless otherwise specified in the instructions.

IMPORTANT SAFETY NOTICES

Carefully observe the safety alert symbols below for
dangers, warnings, and cautions. They alert
installers and operators of possible dangers or
important information contained in this manual.
HOWEVER: Warnings alone do not eliminate
hazards, nor are they a substitute for safe boat
handling and proper accident prevention meas-
ures!
Danger!
Failure to comply with a danger symbol will
result in serious injury or death to boat operator,
boat occupants, and/or others.
Warning!
Failure to comply with a warning may result in
injury or death to boat operator, boat occupants
and/or others.
Caution!
Failure to comply with a caution may result in
failure or damage to the equipment.
NOTE! Special attention should be used to pre-
vent incorrect assembly or disassembly.