Southwire M300P Instrucciones De Uso página 5

Mapeador profesional de cable vdv
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Using the Tone Generator to Trace a Phone Line
NOTE:
It is necessary to use a separate amplifier probe
Southwire Model T120AP (
sold separately)
1. Connect the cable under test to
the RJ11/RJ12 port on the tester.
2. Set the rotary function switch to
the Voice position.
3. Press the MODE button to activate
the Tone Generator.
4. Repeatedly press the Mode button
to select the desired tone.
Refer to sequence chart (A)
for explanation of tone selection.
in order to hear the tone.
Amplifier Probe
(A)
TEST MODE
Lo:
TONE MODE
Low pitch tone
Lo
HI 1:
TONE MODE
Alternating High/
HI 1
Low pitch tone
HI 2:
TONE MODE
Warbling tone
HI 2
7
Operation
Using the Tone Generator to Trace a Phone Line cont.
5. The connector pins the tone is being sent through will be shown on the
bottom of the display. Repeatedly press the CYCLE button to select the
desired pins. Refer to sequence chart (B) below for explanation of
pin selection.
(B)
1
2
3
4
1 6
2 5
1
2
3
4
5
NOTE:
When tracing a cable run from the tone generator to the end of the
cable, applying the tone on a single pin will allow the tone to be detected at a
greater distance from the cable. When trying to locate a cable in an equipment
room or patch panel, sending the tone through all 8 pins or a single pair will
limit the tone signal from spreading to other nearby cables. The tone will be
loudest when the probe tip is placed directly on the wires the tone is being
sent through at the end of the cable. When sending a tone through a single pair,
verification can be made by shorting the suspected pair. The tone will be very
faint when the pair the tone is being sent through is shorted.
5
6
Tone will be sent through
selected pin
Tone will be sent through
3 4
selected pair
Tone will be sent
6
through all 6 pins
8

Publicidad

Tabla de contenido
loading

Tabla de contenido