Kohler K-697 Guia De Instalacion página 9

Cold
2. Bath Only Valve Installation
NOTE: The valve must be installed with the open outlet facing
down for this style of installation.
Flush the hot and cold water supply lines to remove any debris.
Use thread sealant and connect the hot and cold water supply
lines to the valve inlet ports.
NOTE: If the existing hot and cold plumbing is reversed, see the
"Reversed Inlet Supplies" section.
Connect the water outlet lines to the valve ports.
IMPORTANT! Secure the piping to the framing.
IMPORTANT! Secure the valve to the framing in 2x6 installations.
Install the bath spout nipple following the directions included
with the trim.
Go to the "Rotate the Cartridge" section and follow the directions.
Kohler Co.
Hot
9 1066046-2-B