Axxess Interface Installation; Tools Required; Connections To Be Made - Metra 99-7627HG Instrucciones De Instalación

Axxess Interface Installation

FEATURES
• Retains factory screen
• Retains factory back up camera
• Retains factory AUX-IN
• Retains personalization features
• Ability to add aftermarket backup camera or additional video input
• Works in amplified or non-amplified models
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
INTERFACE COMPONENTS
• Axxess Interface
• 7627 harness
• 16, 20, and 32-pin to 12 and 22-pin harness
• 14-pin to 4, 16, and 18-pin extension harness
• 14-pin to 14-pin extension harness wrapped in black tape
• 12-pin harness with (4) RCA jacks
• 20-pin to 24-pin extension harness wrapped in black tape

TOOLS REQUIRED

• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
99-7627HG

Connections to be made

From the 7627 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire. (If the aftermarket radio has
no illumination wire, tape off the Orange wire).
• Tape off and disregard the White/Blue wire, it will not be used in this application.
The following (2) wires are for an aftermarket multimedia/navigation radio
that provide these wires (if not required, tape them off and disregard them):
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• Connect the Green/Purple wire with a female bullet connector to the reverse
wire (if applicable).
• Connect the Green/Purple wire with a male bullet connector, to the
Green/Purple wire with a female bullet connector. Only connect this wire if the
Green/Purple wire with a male bullet connector has a wire populated on the
factory side.
5