STEP :: 07
MATCH THE COLLAR RECEIVER, REMOTE BEEPER,
AND REMOTE TRANSMITTER
To match the Collar Receiver and Remote Beeper to work with a new Remote Transmitter or to program a new
Collar Receiver and Remote Beeper to work with your existing Remote Transmitter:
A. Turn the Collar Receiver and Remote Beeper off.
B. Press and hold the On/Off Button for each. The Collar Receiver and Remote Beeper Indicator Lights will come
on, then turn off after 4-5 seconds. If the On/Off Button is released too early, the Collar Receiver and Remote
Beeper Indicator Lights will begin flashing as normal. If this occurs, start over from A.
C. After the Collar Receiver and Remote Beeper Indicator Lights have turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Collar Receiver and Remote Beeper
Indicator Lights flash 5 times. Once the Collar Receiver and Remote Beeper Indicator Lights have flashed 5
times, the Collar Receiver and Remote Beeper have been matched and the Indicator Lights will begin flashing
as normal. If the Collar Receiver and Remote Beeper Indicator Lights do not flash 5 times, start over from A.
STEP :: 08
PROGRAM THE REMOTE BEEPER
CHANGE TONES
The SportTrainer® SD-1875E has nine tones. The default tone is High Volume Beep. The Remote Beeper
must be matched to the Remote Transmitter to change the tone settings remotely. See STEP 7.
MODE
1
2
3
4
5
6
7
8
9
TO CHANGE THE TONE
1. While the Remote Beeper is on, set the Intensity Dial on the Remote Transmitter to position 7 with the
Toggle Switch in the up position.
2. Press the Mode Button on the back of the Remote Transmitter. The Remote Transmitter LED will illuminate
green.
3. Press the Upper Button on the Remote Transmitter for Dog 1. The Remote Beeper will start cycling through
the tones by playing them one at a time.
4. Once you have heard the tone you want, press the Upper Button for Dog 1 again on the Remote Transmitter
to select that tone. The Remote Beeper will emit 3 beeps to confirm that you selected a tone.
5. You do have the ability to select a different tone for each dog. For Dog 2, follow steps 1-4 using the Lower
Button in place of the Upper Button. For Dog 3, follow steps 1-4 using the Locate Button in place of the
Upper Button.
6. Turn the Intensity Dial one position. The Remote Transmitter's Indicator Light will turn off.
7. Press the corresponding button for each dog (with the toggle switch in the up position) and the
selected tone will play.
18
TONE
High Volume Beep
Double High Beep
High Falling To Low Volume Beep
Double High Falling To Low Volume Beep
Low Volume Hawk
High Volume Hawk
Bob White Quail Call
Triple Beep
Low Volume Beep
WWW.sportdog.com