Locking The Safe - STACK-ON 40-0000119 Instrucciones

To enter your personal security code you will need to follow the steps listed below:
1. After opening the electronic safe (with the preset factory code of 1 - 5 - 9 - #), locate the small red
reset button on the inside of the door near the hinge.
2. Press the red reset button and then release it; you will hear a beep. A yellow light on the faceplate will
activate and stay on for a period of time while you enter your personal security code. You can only
enter the code while the yellow light is illuminated.
With the door open and the yellow light activated, enter your 3 - 8 digit code. Confirm your code by
pressing the ⁕ symbol on the keypad. Before closing the door, enter your code followed by the # symbol
to be sure that it releases the handle and allows you to turn it. You should see the live action bolts retract.
If the code fails, go through steps 1 and 2 again. If the code works successfully, record your combination
and keep it in a secure location away from children and not inside the safe. You should then close and
lock the door.
NOTE: DO NOT SHUT THE DOOR UNTIL YOU HAVE CONFIRMED THAT YOUR NEW SECURITY
CODE WORKS CORRECTLY.

Locking The Safe

To lock the safe, close the door and rotate the handle counterclockwise until it stops. If the handle is not
turned until it stops, the locking mechanism will not lock.
NOTE: Because the locking mechanism is deactivated for approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6 seconds from the time the combination is entered to
lock the safe.
NOTE: Always confirm the door is closed and the lock has engaged before leaving the safe unattended.
Lockout Mode
If an incorrect security code is entered 3 times the safe will automatically lockout for 15 seconds before you
can try your code again. If the incorrect code is entered 2 additional times there will be a 5 minute lockout
before you can try your code again.
Silencing the Keypad
You can turn off the "Beep" sound of the keypad by entering the code
To turn the "Beep" sound on, enter the code - 6 - 6.
- 6 - 3 - 3.
40-0000119-2103
3
12