Invacare InTouch ITFG Manual Del Usuario página 3

Attaching/Removing the Cushion To/From the Seating Surface
NOTE: For this procedure, refer to FIGURE 1.
NOTE: To remove the cushion from the seating surface, reverse the following procedure.
NOTE: The seating surface can be one of the following: seat upholstery, drop base or seat pan.
NOTE: The zipper on the cushion should ALWAYS face rearward.
Make sure the hook and loop fasteners are securely attached to the seating surface and to the
cushion BEFORE using. If the cushion is not secured to the seating surface, use caution when
transferring in and out of the wheelchair.
Hook Attachment Strips/No Attachment Strips
1. Remove double sided hook from bottom of cushion.
2. Align front edge of cushion with front edge of seating surface.
3. Perform one of the following:
• Hook Attachment Strips ‐ Secure the cushion to the seating surface, making sure that the strips of
loop on the cushion cover are securely attached to the strips of hook on the seating surface.
• No Attachment Strips ‐ Place the cushion on the seating surface.
Loop Attachment Strips
1. Verify the double sided hook strips are securely attached to the loop attachment strips on the bottom
of the cushion.
2. Align front edge of cushion with front edge of seating surface.
3. Secure the cushion to the seating surface, making sure that the double sided hook is securely attached
to the strips of loop on the cushion cover and the seating surface.
Zipper Faces Rearward
Loop Portion of Fastening
Strap (Attached to Cushion)
Double Sided Hook
Portion of Fastening
Strap (Remove backing if
necessary)
FIGURE 1 Attaching/Removing the Cushion To/From the Seating Surface
Part No 1141447
Seating Surface
WARNING
3
Cushion
Front of cushion lines up
with front edge of
seating surface
InTouch™ Flovair Cushion