ShelterLogic AutoShelter 62680 Instrucciones De Montaje página 7

DETAIL M
7. InStAllInG cover AnD cover rAIlS:
A. Lay the cover on the ground next to the frame with inside of the cover (the side
with the pipe pockets) facing down and the webbing on the front and rear of the
corner of the building. Pull cover over the frame.
B. Assemble ratchets as shown in Detail O and P. Disassemble cover rails and
slide through fabric pockets at each leg and re-secure with clamps. See Detail R.
Repeat this on other side. Push down on cover rails to tighten cover, before tight-
ening bolts completely.
WARNING: Serious injury to persons or property could result if cover is installed
and shelter is not anchored and is left unattended. Shelter must be securely
anchored.
NOTE: EnsUrE covEr is
corrEctly placEd on thE
framE. The shelterlogic
should line up on the left front and
right rear corners near the top rail. If
the logo is not legible, the cover has
not been put on the frame correctly.
Cover Tightening Tip
Check and
tighten Ratchets
and Cross Rails
monthly to ensure
the cover is tight.
CORRECT
INTERIOR
DETAIL N
WEBBINg
logo
®
CORNER LEg
BRACKET
CORNER LEg
13345
COVER RAILS
DETAIL Q
HOOK CONNECTOR-INSIDE VIEW
FRAME FOOT
WITH HOLES
DETAIL R
800163
Page 7
DETAIL O
WEBBINg-OUTSIDE VIEW
"S" HOOK HOLE
DETAIL P
WEBBINg, RATCHET AND "S"
zIPPER
DOOR
DETAIL F
10115
01011
01010
CORNER LEg
10115
01011
01010
CLAMPS
MIDDLE LEg
13201
CLAMPS
13202
05-62680-0B