Kit Assembly - Metra Electronics 99-7811 Instrucciones De Montaje

1. Attach the clips removed in step 10
of dash disassembly to the same
locations on the radio trim panel.
2. Attach the radio brackets to the
pocket using the (4) #8 x 3/8"
Phillips screws provided. (Figure A)
3. Attach the radio bracket/pocket
assembly to the radio trim panel
using (4) #8 x 3/8" Phillips screws
provided. (Figure B)
4. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
5. Slide the radio into the completed
assembly from the back, and then
secure it using the screws supplied
with the radio. (Figure C)

Kit Assembly

(Figure A)
(Figure B)
99-7811
6. Attach the factory vents to the
radio trim panel using the screws
removed in step 11 of dash
disassembly.
7. Locate the factory wiring
harness and antenna connector
in the dash, and complete all
necessary connections to the
radio and climate controls. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for
proper operation.
8. Reassemble the dash in reverse
order of disassembly.
5
(Figure C)