Maintenance; Daily Maintenance - Airwell AW-CFV09/07-N11 Manual De Usuario E Instalacion

Maintenance

• Repair can only be performed by professional personnel.
• Before touching the connection line, all power supplies should be switched off. Only after switching off the power
supply can the operator clean the air conditioner as to avoid electric shock or injury.
• When cleaning the air cleaner, make sure to use a stable platform; don't flush the air conditioner with water, or the
electric shock might be caused.

Daily Maintenance:

Clean the air cleaner & air inlet grid.
• Don't dismantle the air cleaner if not cleaning, or faults might be caused.
• When the air conditioner operates in the environment with too much dust, clean the air conditioner more times (generally
once every two weeks).
1. Remove the air inlet grid as shown in the figure: press down the two locks on the grid (as shown in Fig. 1) to move it
close to the nearby grid, gently lift it 45 degree (as shown in Fig. 2), and then remove the air inlet grid.
2. Dismantle the gauze: press the outer frame of the air inlet grid by the thumb, and draw the base angle of gauze by the
forefinger and pull it out as to make the gauze disengage the locks, and dismantle the gauze (as shown in Fig. 3).
press down the locks
Fig. 1
Cleaning Air Cleaner
• Cleaning
Clean the air cleaner with the dust collector or water to remove dusts.
For too much dust, use the fan or directly spray the special cookware detergent on the air inlet grid, and then clean it
with water after 10 minutes.
(A) remove dust with dust collector.
(B) for too much dust, use soft-hair brush and mild detergent to clean.
(C) throw off water and then dry it at cool places.
• Don't clean it with hot water of over 50°C to avoid fading or distortion.
• Don't dry it on the fire, or the cleaner might cause fire.
Attention
remove air inlet grid
Fig. 2
Attention
lock device
bottom of gauze
lock port
4
locks
lock device
frame of air inlet grid
Fig. 3