Maintenance And Cleaning Instructions; Replacing The Carbon Brushes; Lubrication; Cleaning And Storage - VITO PRO-POWER VISCME210 Manual De Instrucciones

MAINTENANCE AND CLEANING INSTRUCTIONS

Before performing cleaning, adjusting, repairing
and maintenance work, switch the appliance off
and unplug the power cord. Wait for the blade to stop
completely.
The saw does not require any additional lubrication or
maintenance. However, you must perform regular
cleaning for a continuous and trouble-free operation.
Always keep saw blades clean and sharp. Properly
maintained blades jam less frequently, are more easily
controlled and allow greater efficiency during use of the
appliance.

Replacing the carbon brushes

The motor will not start if the carbon brushes are worn
out. The brushes must be replaced in time, otherwise
there will be poor contact between the brushes and the
rotor, which may lead to sparks and damage to the tool.
The two brushes should be replaced at the same time
by two brushes with equal characteristics.
1. Unscrew the carbon brush cap (23);
2. Remove the worn-out carbon brushes and insert the
new ones;
3. Place the carbon brush cap and tighten.

Lubrication

The moving parts of the power tool (slide rail and
spindles) must be kept constantly greased to ensure the
best performance and the expected service life.
Lubrication should be frequent, but not excessive. Apply
only a few drops of grease, after each use, to ensure
power tool's good performance.

Cleaning and storage

Cleaning
You can get information regarding the disposal of the
power tool through the person in charge for recycling in
your city.
After each use, clean all the components of the sliding
miter saw. Wipe the power tool with a clean, damp
cloth or blow it with low pressure compressed air.
Careful handling protects the power tool and extends its
service life.
Storage
When not in use, store the sliding miter saw in a dry,
clean place, free of corrosive smoke and out of
children's reach.

ENVIRONMENTAL POLICY

The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your
household waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.

CUSTOMER SERVICE

Tel.: +351 256 248 826
E-mail: international@centrallobao.pt
Website: www.centrallobao.pt
35