Adjusting the bevel angle
1. Loosen the bevel locking lever to tilt the cutting head
to the left according to the desired bevel angle (0°-
45°);
2. The bevel angle indicator indicated the angle
selected on the scale.
Using the slide rail
The slide rail (3) allows the cutting head move along the
workpieces, enabling larger cuts;
To cut with the cutting head fixed in a certain position:
1. Slide the cutting head backwards and tighten the
locking bolt on the slide rail;
When performing slide cut:
2. Slide the cutting head backwards and move the
cutting head along the slide rail.
Cutting procedure
1. Raise the saw head and pull it out over the workpiece
without cutting;
2. Press the ON/OFF switch (20);
3. Press the saw head down and push the saw through
the workpiece.
Do not pull the saw through the workpiece when
the power tool is running.
Laser guide
Use the laser guide (6) to ensure that you cut the part
to the desired size.
To switch on the laser, press the switch (22).
34
Sliding miter saw transport
Always secure moving parts before carrying the
appliance.
1. Ensure that the spindle is locked;
2. Ensure that the miter locking handle (13) is
tightened;
3. Slide the cutting head backwards all the way and
tighten he locking bolt;
4. Push the cutting head down and press the head lock-
down pin (19);
5. Always carry the tool by it carrying handle.
The lower position of the cutting head, is for
transport and storage purposes only. Do not use
the saw head in this position to cut.