ADE Doreen Manual De Instrucciones página 6

Thank you for purchasing these high-quality body analysis scales.
Please read these Operating Instructions carefully before using the product for the first
time, and keep them in a safe place so that you can consult them again if you need
further information.
1. How do body analyser scales work?
With these new revolutionary scales you will receive information on your body
composition regarding weight, percentage of body fat %, body water %, muscle mass
%, bone mass kg, BMI and your Basal Metabolic Rate (energy requirement) kcal.
To start, enter all the personal data, e.g. gender (male or female), age and height.
This information must be stored in your personal memory location just once. After that,
the process is as easy as on any regular scales. You only need to choose your individual
memory button, step onto the scales and in just a few seconds your current body status
will be displayed. A small electrical current is used to measure the resistance. Water,
which is mainly contained in muscles, is a good conductor, fat on the other hand blocks
the current. Taking the measured resistance and the stored data into consideration, the
body analyser scales can very precisely calculate your body composition.
2. Conditions of use
The measurements should take place without clothes, if possible, and always barefoot.
Since the body is subject to natural fluctuations (e.g. dehydration through sports or
sauna, intake of food and fluids), constant conditions should be ensured when
measuring, so as to receive comparable values.
Care should be taken that the measurements are always carried out at the same time of
day. Directly after getting up in the morning, the water has not yet spread through the
body. This means that the resistance is still relatively high, due to the bad conductivity in
the body. With increasing movements throughout the day, the water spreads through the
body, increasing conductivity, which causes the resistance, and thus the fat level too, to
be shown as lower. To determine the actual changes of body composition, it is therefore
important to measure always at same time. An easy way of doing this is by always
measuring a quarter of an hour after getting up in the morning, either before or after
using the toilet.
Despite the minimum cu rren t, persons with pacemakers or othe r implan ts, which
emit frequenc ies, must not use the body analyser scales! Other implants, e.g. a
titanium plate in the knee, pose no danger. Metals, however, conduct electricity
extremely well, which has the effect that body fat values are "beautified", meaning that
the actual fat level is higher than shown by the scales. Tendencies, on the other hand,
can be determined just as well. In women, menstrual factors have an effect on the
measurement results, since hormonal fluctuations influence the body's water balance. If
the body contains all lot of water, the fat values are lower, if less water is contained the
2
7. Error messages
"Err" = Overload – The 180 kg maximum load capacity has been exceeded.
Remove the object from the scales immediately to avoid damaging the
scales' load cell unit.
Or: Faulty weighing / measuring process - For example, if the scales are
unstable or you are not standing still on the weighing platform.
"Lo" = Batteries low – Please replace with the appropriate battery type (4 x 1.5
V AAA).
"ErL" = Fat percentage % too low – lower than 5 % cannot be displayed.
"ErL" = Fat percentage % too high– higher than 50 % cannot be displayed.
8. Technical data
Load capacity x gradation: Max. 180 kg x 100 g
Display resolution: Percentage of body fat: 0.1 %
Display resolution: Percentage of body water: 0.1 %
Display resolution: Percentage of muscle mass: 0.1 %
Display resolution: Bone mass: 100 g
Pers. memory locations: 10
Age: 10 – 80 years
Height: 100 – 240 cm
Dimensions: approx. 350 mm x 300 mm x 23 mm
Batteries: 4 x 1.5 AAA (included)
Subject to technical changes
9. Warranty
ADE agrees to rectify any material or manufacturing defects by offering free repair or
replacement, for a period of 3 years from the purchase date. At the time of purchase,
please get the retailer to fill in and stamp the guarantee card. In the case of guarantee
claims, please return the scales to your retailer including guarantee card and stating the
reasons for the claim.
CE conformity. This device is interferenc e-supp ressed in acc ordance
with the applicable EU Directive 2004/108/EC
Note: Extreme sources of electromagnetic radiation, such as those caused by the
operation of radio equipment in the vicinity of the scales, can affect the value displayed.
The product will return to proper function as soon as the interference has been eliminated.
Note: the unit may need to be restarted.
7