Determinating The Air Quality (Only Wöhler Fa 430); Measuring Relative Humidity; (Wöhler Fa 430 Only); Measuring The Co Concentration (Wöhler Fa 430 Only) - Wohler FA 410 Manual De Instrucciones

5.4 Determinating the air
quality
(only Wöhler FA 430)
5.4.1 Measuring relative hu-
midity
(Wöhler FA 430 only)
5.4.2 Measuring the CO
concentration
(Wöhler FA 430 only)
5.5

Freezing readings

A good air quality is decisive for the comfort of
persons. Therefore many new guidelines , e.g.
VDI 6022-3 and DIN EN 15251, are based on the
determination of the air quality. The Wöhler
FA 430 does not only determine the amount of
circulating air but it also determines the quality of
this air. According to VDI 6022-3 and DIN EN
15251 the humidity and the CO
important parameters. The Wöhler FA 430
measures these values and the volume flow at the
same time.
Press the Up key until the relative humidity is
•
displayed in the top part of the display.
NOTE!
It is possible to set an offset value for the relative
humidity in the Setup menu, please refer to Chap-
ter 6.3.
Press the Up key until the CO
•
2
displayed.
NOTE!
When measuring at high altitudes, take the pres-
sure into consideration to obtain a precise CO
reading. Before beginning to take measurements
at high altitudes, enter the absolute pressure of
your location under position 4.0 in the Setup
mode; please refer to Chapter 6.4.
• Press the HOLD/MIN/MAX key.
The readings in the top and lower parts of the
display are frozen.
To return to the normal Measuring mode,
•
press the HOLD key again.
Operating the fan anemometer
are the most
2
reading is
2
EN
2
47