Publicidad
Idiomas disponibles
Idiomas disponibles
3-5/8"
21-1/8"
(92 mm)
(537 mm)
Pump/Control Access
20" (508 mm) W x
15" (381 mm) H Min
2-7/8"
(73 mm)
3" (76 mm)
Product Information
Applicable product:
5' Custom bath whirlpool with heater, drop-in
Fixture*:
Bathing well:
Basin area, bottom
42" (1067 mm) x 28" (711 mm)
Basin area, top
55" (1397 mm) x 40" (1016 mm)
Weight
115 lbs (52 kg)
To overflow:
Water depth
15-1/2" (394 mm)
Capacity
73 gal (276 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template
Recommended accessories:
Adjustable pop-up bath drain
V
Pump: 1-speed
120
Heater: 1.5 kW
120
1017027-1-C
11" (279 mm)
60" (1524 mm)
3-1/4" (83 mm)
1" (25 mm)
1-1/2" OD
K-1337-HN
1017044-7
K-7166-AF
Hz
A
60
7.5
60
12.5
No change in measurements if connected
with drain illustrated. (K-7166-AF)
1-1/4"
(32 mm)
21"
(533 mm)
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Heater
Locate the outlets behind the whirlpool and within 24" (610
mm) of the pump and heater.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
43 lbs/square foot (208 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The pump must be relocated to the custom position at the time of
installation. Provide adequate clearance. Two minimum access
panels are required as illustrated. These should be 20" (508 mm)
wide and 15" (381 mm) high.
This fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
2
42-1/4" (1073 mm)
120 V, 15 A, 60 Hz
120 V, 15 A, 60 Hz
Kohler Co.
Publicidad
