GYS M1 AUTO Manual De Instrucciones página 25

maintenance
• Maintenance should only be carried out by a qualified person.
• Ensure the machine is unplugged, and that the ventilator inside has stopped before carrying out maintenance work.
(DANGER High Voltage and Currents).
• JBDC recommends removing the steel cover 2 or 3 times a year to remove any excess dust. Take this opportunity to
have the electrical connections checked by a qualified person with an insulated tool.
• Regularly check the condition of the power supply cord. If damaged, it will need to be replaced by the manufacturer,
its' after sales service or a qualified person.
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
• Before each use, check the state of welding cables of the torch and earth clamp (The conductive metal should not be
exposed).
Safety
Arc welding can be dangerous and can cause serious and even fatal injuries.
Protect yourself and others. Ensure the following safety precautions are taken:
arc radiation:
rain, steam, damp:
electric choc:
falls:
Burns:
fire risks:
fumes:
additional Precautions:
People wearing Pacemakers are advised to see their doctor before using this device.
People wearing Pacemakers are advised not to use this machine, however if necessary, please
handle gas bottles with care - there is increased danger if the bottle or its valve are damaged.
6
generalitieS
Protect yourself with a helmet fitted with filters in compliance with EN169 or
EN 379.
Use your welding unit in a clean/dry environment (pollution factor ≤ 3), on a
flat surface, and more than one meter from the welding work-piece. Do not use
in rain or snow.
This device must only be used with an earthed power supply, single-phase or
three-phase depending on model. Do not touch the parts under high voltage.
Check that the power supply is suitable for this unit.
Do not place/carry the unit over people or objects.
Wear protective (fire-proof) clothing (cotton, overalls or jeans).
Wear protective gloves and a fire-proof apron.
Ensure other people keep a safe distance from the work area and do not look
directly at the welding arc.
Protect others by installing fire-proof protection walls.
Remove all flammable products from the work area. Do not work in presence
of flammable gases.
Do not inhale welding gases and fumes. Use the device in a well ventilated
environment, with artificial extraction if welding indoors.
Any welding operation undertaken in.....
- rooms where there is an increased risk of electric shocks,
- Poorly ventilated rooms,
- In the presence of flammable or explosive material,
Use should always be approved by a «responsible expert», and made in
presence of people trained to intervene in case of emergency.
Technical protection as described in the Technical Specification CEI/IEC 62081
must be implemented. Welding in raised positions should not be undertaken,
except in case of safety platforms use.
seek medical advice prior to use.
do not use the welding unit to unfreeze pipes.
en