Publicidad
e
Problem
Bubbles do not flow
from one or both
bubble chambers
Bubble solution
is leaking from
the mower
e Problems and Solutions
f Problèmes et solutions
S Problemas y soluciones
P Problemas e Soluções
Cause
Not enough bubble
solution in chamber(s)
Bubble chamber wheel(s)
is clogged and dirty
You have not walked
far enough to produce
bubbles
You are walking
too quickly
The rear wheels are not
contacting the ground
Silicone or oily lubricants
may have gotten in the
bubble chamber(s)
Bubble chamber(s)
over-filled
The mower is used on
an incline
Solution
Refill chamber(s) with
enough bubble solution.
Follow instructions
in "Let's Clean Up"
section to clean bubble
chamber thoroughly.
The bubble mower needs
to be pushed a minimum
of 15-20 walking steps
before bubbles begin
to flow.
Walk at a slow,
steady pace.
Push the mower so that
the rear wheels are always
contacting the ground.
Never use silicone or oily
lubricants on this product
(the wheels). Bubbles will
not form if even a very
small amount of these
substances get into
the bubble chamber(s).
Fill only until bubble
solution reaches top of
bubble chamber.
Use the Bubble Mower
only on flat, level ground.
10
Publicidad
