Getting Started; Setting Time And Date - Medisana MTP Pro Instrucciones De Manejo

GB

3 Getting Started

3.2
Using a Mains
Adaptor
3.3
Setting time
and date
3.4
Setting up the
user memory
20
Alternatively, you can use the unit with a special mains adaptor (MEDISANA
Art.–No. 51036) This connects
unit. In this case the batteries remain in the unit.
Inserting the connector into the back of the blood pressure monitor switches
the batteries off mechanically. It is necessary, therefore, to plug the mains
adaptor into the mains socket first of all and then to connect it to the blood
pressure monitor. If the blood pressure monitor is no longer being used, first
remove the connector from the blood pressure monitor and then pull the mains
adaptor out of the mains socket. Doing this means that the date and time will
not have to be reset each time.
To set date and time press and hold the TIMER button
The symbol for the memory selected starts blinking. Now press the TIMER
button again briefly. The year is now shown in the display
blinking. Press the MEMORY button
button to go to month, day and time. Press the MEMORY button
change the values.
The MTP Pro gives you the opportunity to assign readings to one of two user
memories, each of which provides 99 memory slots.
Press and hold the TIMER button
memory (USER) 1
1
between USER 1 and USER 2 by pressing the MEMORY button
to the socket provided at the back of the
to change the year. Press the TIMER
for several seconds. The symbol for
in the display starts blinking. You can switch
for several seconds.
and starts
to
.