Le Chai LBN458PO Manual De Instrucciones página 60

The UV system:
The light accelerates aging of your wines. In full doors cellars, the wines are naturally immune subject of
course limited openings). This model glass door was subject of a particular treatment, which filters
harmful ultraviolet rays; the wines are perfectly safe.
Defrost:
This product does not produce frost (No-Frost). There is no frost or ice; so, no operation is required to
remove it.
Shelves
To prevent damage to the door seal, make
sure the door is open before pulling the
shelves to install or remove the bottles.
For easier access to the contents of shelves
you need to slide the shelf outward about
1/3 however they are designed with a stop
on each side to prevent the bottles from
falling.
To remove or position the shelves, move the
shelf to the position where the notch of the
wooden shelf is exactly under the plastic
rack stop and then lift it up and out.
DOOR OPENING MECHANISM (PUSH-AND-OPEN DOOR FUNCTION)
The push-and-open door function (if your model supplied with it) is activated when the unit is powered.
To open the door, push the door slightly inwards on the top leftpositionfor the right hinge model (the top
right position for the left hinge model)and then release it again.The unit will beep once to confirm the
action.The door will be opened approx.2~7cm by the push rod. Thenthe door can be fully open manually.
The push rod will return to its initial position after 3 seconds automatically. And the unit will beep once
again and it is ready for next opening action.
NOTE:
- The door will close again automatically after approx. 3 seconds if it has not been fully opened manually
for models with automatic door closing function.
- Do not block the door or hold on it while it is opening. If the door is blocked or held during opening, the
door opening mechanismand the door will be damaged. The loud and repeated cracking noises will be
heard.
- Do not push the push rod in or hold on to it during closing. If the push rod is blocked during closing, it
will no longer be able to reach its initial position. In the initial position, the push rod is flush with the front
of control panel. In order to set the push rod back in its initial position, disconnect the appliance from the
mains, wait for approx. 10 seconds and plug it back in again. The push rod will return to its initial
position.
LOADING
The maximum number of bottles that can be loaded into the cabinet are for information only; this
information is not contractual; it provides a means for rapidly estimating the size of the device.
The information comes from tests carried out using standard bottles; in reality, in extreme conditions it
would be possible to load a greater number of bottles without racks, but a "diverse wine cellar" is used in
many different ways; the daily use of a wine cabinet means that it must carry fewer bottles. Therefore
you will probably load fewer bottles then the given maximum numbers.
60