Care Of Your Cabinet - Le Chai LBN458PO Manual De Instrucciones

when the door is open. If you are in showcase mode, the lights will be on whether or not the door is
open. The unit is equipped with a LED light fitting system. To change the LED light fitting pls contact the
service department.
NOTE: Please use only the original LED light fittings provided by the manufacturer.
 Note

If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine cooler will not start.
 When you use the Wine cooler for the first time or restart the Wine cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the Wine cooler is running for a few hours everything will be back to normal.
DEFROSTING
Defrosting of your wine cabinet is fully automatic. It requires no action on your part.
During operation, you may notice condensation drops forming on the rear inside wall of the cabinet. They
will be eliminated during automatic defrosting.
CLEANING
Before any cleaning, unplug the device from the mains.
Never use abrasives or a scraper sponge when cleaning the inside or the outside of your wine
cabinet.

Remove all accessories (racks, etc.). Wash them using lukewarm water to which has been added a
gentle unscented detergent (dishwashing liquid for example); rinse with bleach water and carefully
dry off.

Wash the inside walls in the same way; pay particular attention to the rack supports

Wash the door seal as well as under the seal.

Plug the wine cabinet into the mains.
From time to time, dust off the condenser under the device; accumulated dust may reduce the efficiency
of your wine cabinet.
In the event of a prolonged absence, empty and clean out the device; maintain the door slightly open
during the period of non-use.
REPLACING THE ILLUMINATING LAMP
The device uses light emitting diodes (LEDs). This type of diode cannot be changed by the user. The life
cycle of the LEDs is long enough so that they do not need to be changed. If however, in spite of the care
taken by the manufacturer, the LEDs do fail, please contact your Customer Care Service for any repair.

CARE OF YOUR CABINET

64