Makita JS1000 Instrucciones Originales página 3

ENGLISH
(Original instructions)
1 Switch lever
2 Hex wrench
3 Screw
SPECIFICATIONS
Model
Max. cutting capacities
2
Steel up to 400 N/mm
2
Steel up to 600 N/mm
2
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Min. cutting radius ....................................................................... 30 mm
Strokes per minute (min
Overall length .............................................................................. 322 mm
Net weight .................................................................................... 1.4 kg
Safety class .................................................................................
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Explanation of general view
4 Thickness gauge
5 Center blade
6 Side blade
............................................................. 1.0 mm (20 ga.)
............................................................. 0.7 mm (23 ga.)
............................................................. 0.5 mm (26 ga.)
2
..................................................... 2.5 mm (12 ga.)
-1
)............................................................ 4,500
JS1000
/II
SHEAR SAFETY WARNINGS
1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
ENE037-1
4. Edges and chips of the workpiece are sharp.
Wear gloves. It is also recommended that you
put on thickly bottomed shoes to prevent injury.
5. Do not put the tool on the chips of the work-
ENF002-2
piece. Otherwise it can cause damage and trou-
ble on the tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
GEA010-2
8. Do not touch the blade or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9. Avoid cutting electrical wires. It can cause seri-
ous accident by electric shock.
10. Do not operate the tool at no-load unnecessarily.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this instruc-
tion manual may cause serious personal injury.
7 Hex socket head bolt
8 Pin
JS1601
1.6 mm (16 ga.)
1.2 mm (18 ga.)
0.8 mm (21 ga.)
2.5 mm (12 ga.)
250 mm
4,500
320 mm
1.4 kg
/II
GEB027-3
3