Assembly & Adjustments - Cub Cadet ST15E Manual De Instrucciones

NOTE:
All references to the left or right side of the string trimmer are
from the operator's position. Any exceptions will be noted.
To reduce the risk of serious personal injury, turn unit
off and remove the battery pack before making any
adjustments or removing/installing attachments or
accessories, when replacing line, or prior to cleaning. An
accidental start-up can cause injury.
Never remove the guard. Damage or personal injury
could result.
Never operate appliance without guard firmly in place.
The guard must always be properly attached on the
appliance to protect the user.
Assembling the Guard (Figure 1)
1. Assemble the guard
(8) to the motor
housing (5) as shown
in Figure 1.
2. Using a crosshead
screwdriver,
insert the two
guard screws and
tighten securely.
An extended coverage guard
is available (sold separately)
for extra coverage, if desired. See separate supplement for
replacement guard information.
Assembling the Pole (Figures 2-4)
1. DO NOT remove the zip tie until the pole is assembled.
2. Ensure that the sleeve (14) on the lower trimmer pole (6)
is fully extended.
NOTE:
To
17
adjust the
sleeve, release
the sleeve
latch (15) and
move the
sleeve into
position.
ASSEMBLY & ADJUSTMENTS
WARNING
WARNING
WARNING
5
Figure 1
14
18
Figure 2
3. Lock the sleeve latch.
4. With the sleeve latch closed, slide the upper trimmer
pole into the sleeve lower trimmer pole. The latching
button (17) will click into position when it engages the
latch hole.
5. Tighten the top screw (18) with a crosshead screwdriver.
14
Figure 3
Adjusting the Auxiliary Handle (Figure 5)
The auxiliary
handle (4) is
positioned to
maximize balance.
However, if
adjustment is
8
necessary, release
the auxiliary
handle latch
(19) and slide
the handle up or
down the upper
trimmer pole until
it is in the desired
location. Close the
auxiliary handle
latch to lock the handle in place.
15
6
11
17
18
15
Figure 4
19
4
Figure 5