Cub Cadet ST15E Manual De Instrucciones página 14

Reloading the Cutting Line (Figures 12-14)
To reduce the risk of serious personal injury, turn unit off and
remove the battery pack before making any adjustments
or removing/installing attachments or accessories, when
replacing line or prior to cleaning. An accidental start-up can
cause injury.
Use on original manufacturer replacement spools and line.
Using any other manufacturer's line can reduce performance,
damage the trimmer or cause personal injury. Your trimmer
uses 0.080" (2 mm) or 0.095" (2.4 mm) diameter line that is
spiral-shaped with smooth round edges. DO NOT use other
size lines. This can degrade performance, cause damage to the
unit or injury.
To avoid appliance damage, if the cutting line protrudes
beyond the trimming blade, cut it off so that it just reaches
the blade.
OPERATION
WARNING
CAUTION
CAUTION
Use on original manufacturer
replacement line:
1. Remove battery.
2. Cut a max of 20' (6
m) length of 0.080"
(2 mm) or 0.095" (2.4
mm) trimmer line.
3. Align spool housing
eyelets (21) with the
arrow (22) on the
spool grip cover
(20) as shown in
Figure 12.
4. Thread one end
of the trimmer
line through an
eyelet. Guide the
line through to the
second eyelet and
continue to pull
the line through
until there are equal
lengths of string
on each side of the
spool housing as
shown in Figure 13.
5. Secure the spool
cap (29) from
moving with one
hand. Using your
other hand, wind
the string onto the spool by rotating the spool grip cover
counter-clockwise. Continue winding until 6" (154 mm)
of string remain on each side of the spool housing.
14
22
21
Figure 12
29
21
Figure 13
Figure 14
20