Flash Duration; Pause Duration - GE 29438 Guia Del Usuario

F D
LASH URATION
You can change the duration of the FLASH
button in order to match your local custom
calling services if you are having trouble
when using the default setting of 600
milliseconds.
The time can be set from 100 - 900
milliseconds (in increments of 100
milliseconds):
1. Press STORE/IN.
2. Press a number on the keypad 1-9
(representing 100 ms each). To set to the
default, press 0.
3. Press STORE/IN and then press the
FLASH button.
P D
AUSE URATION
The default setting for the PAUSE button is
auto tone, which pauses until there is a dial
tone. However, you may need to change the
duration of the PAUSE button in order to
match the amount of time needed to
complete chain or link dialing.
The delay can be set from 1 - 9 seconds (in
1 second increments):
1. Press STORE/IN.
2. Press a number key to choose the
seconds (1-9, auto tone is 0).
3. Press STORE/IN and then press the
PAUSE button.
TIP: You might have to experiment in order to
get the exact timing for access to a particular
service; thus it may be easier to use chain
dialing and wait for each access tone before
pressing the next memory location button.
26
STORE/IN button
1
2
3
4
5
6
7
8
FLASH BUSY REDIAL PAUSE
1
4
GHI
7
PQ
RS
TONE *
MUTE
FLASH button
9
10
11
12
13
14
15
LOWER
16
TWO LINE DATAPHONE
SET MEMO
REDIAL
CONF
2 3
ABC DEF
2
line
5 6
JKL MNO
1
line
8 9
WX
TUV
YZ
0 #
OPER HOLD
VOL
SPEAKER
PAUSE button