Fitting Cutting And Grinding Discs; Securing/Releasing The Quick Clamping Nut (11): For Type; Grinding Wheel Use Only; Securing/Releasing The Clamping Nut (12): For Type 1 Cut-Off Wheels Or Type 27 Grinding Wheels - Metabo W 7-115 Instrucciones De Manejo

9.1

Fitting cutting and grinding discs

Locate the inner flange (10) for type 1 cutting
discs, (10) for type 27 wheels 5" diameter or
smaller, or (14) for type 27 wheels 6" diameter, as
illustrated, ensuring that the inner flange cannot
turn on the spindle.
Position the cutting disc or the grinding disc on the
inner flange, as illustrated, ensuring that the cutting
disc is supported evenly by the inner flange. When
cutting, the sheet metal flange on the cutter disc
should be resting on the inner flange.
9.2 Securing/releasing the Quick
clamping nut (11): For Type 27

grinding wheel use only

Securing
For tools which are thicker than 8 mm
(5/16") in the clamping area, use the
clamping nut (12) with the pin spanner
(13) instead of the Quick clamping
nut (11).
10
10
14
11
Fit the Quick clamping nut (11) in the grooves on
the spindle as illustrated. Lock the spindle in
position. Turn the Quick clamping nut (11)
clockwise by hand until tight. Tighten the Quick
clamping nut by turning the grinding wheel firmly
in a clockwise direction.
Releasing
After switch-off, the angle grinder runs on for
approx. 5 seconds. Press the spindle-lock button
(2) shortly before the grinding tool comes to a
final halt and the Quick clamping nut releases
itself.
Using the spindle-lock button (2) to stop
the spindle is only permitted if the
Quick clamping nut is in use!
Screw the Quick clamping nut off.
9.3 Securing/releasing the
clamping nut (12):
For Type 1 cut-off wheels OR
Type 27 grinding wheels
Securing
For wheels thinner than 3/16" turn clamping nut
(12) onto the spindle with the raised collar away
from the wheel so that the wheel can be clamped
securely. Tighten securely using spanner wrench
(13).
For wheels 3/16" and thicker, turn clamping nut
(12) onto spindle with the raised collar facing the
wheel so that the collar engages the ID of the
wheel. Tighten securely using spanner wrench
(13).
ENGLISH
12
12
12
14
11