Fitting The Backing Pad And Sanding; Fitting The Wire Brush; Fitting The Cup-Grinding Wheel With Wheel Guard - Metabo W 7-115 Instrucciones De Manejo

12.3

Fitting the backing pad and sanding

disc
Use only the clamping nut supplied
along with the backing pad.
Locate the backing pad (i) on the spindle, as
illustrated. Mount the sanding disc (k) with the
backing pad clamping nut supplied. Lock the
spindle in position. Tighten the sanding disc and
backing pad by turning clockwise by hand.
Slacken off manually or with the pin spanner (13),
as necessary.
12.4

Fitting the wire brush

Fit the hand guard.
Remove the wheel guard (4). Lock the spindle in
position. Mount the wire brush (f) and tighten with
the 22 mm AF open-ended spanner (7/8").
12.5 Fitting the cup-grinding wheel with
wheel guard
Remove the wheel guard (4). Fit the cup-grinding
wheel guard to the angle grinder, turning it on in
the direction indicated by the arrow until fully in
position. Use a screwdriver to tighten the screw.
Locate the inner flange (10) on the spindle,
ensuring that the flange cannot turn on the
spindle. Position the cup-grinding wheel so that it
rests evenly on the inner flange.
Screw the clamping nut (12) or the Quick
clamping nut (11) onto the spindle. Lock the
spindle in position. Secure the cup-grinding wheel
with the clamping nut (12) or the Quick clamping
nut (11).
Use the offset pin spanner (n) if the clamping nut
(12) is being used.
Set the cup-grinding wheel/wheel guard
projection as required (approx. 0.5 - 1 cm/
ENGLISH
10
13