Inserting/Replacing Batteries (See Figure A); Starting Operation - Bosch PLL 5 Manual Original

18 | English
Line laser
Batteries
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions
(e.g. direct sunlight).
B) when the measuring tool is positioned correctly(see "Positioning the Measuring
Tool (see figure B)", page 19).
C) Only non-conductive deposits occur, whereby occasional temporary conductivity
caused by condensation is expected.
The serial number (14) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Replacing Batteries (see figure A)
It is recommended that you use alkaline manganese batteries to operate the
measuring tool.
To open the battery compartment cover (10), push the locking mechan-
ism (9) in the direction of the arrow and remove the battery compartment
cover.
Place the battery-recovery ribbon under the first battery being inserted. In-
sert the supplied batteries in the sequence shown in the figure, paying atten-
tion to the correct polarity.
Always replace all the batteries at the same time. Only use batteries from the
same manufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it
u
for a prolonged period of time. The batteries can corrode and self-dis-
charge during prolonged storage in the measuring tool.
Operation

Starting Operation

Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or
u
variations in temperature. For example, do not leave it in a car for ex-
1 609 92A 56M | (23.08.2019)
PLL 5
2 × 1.5 V LR3 (AAA)
0.12 kg
142 × 27 × 30 mm
Bosch Power Tools