Current Measurement - ADInstruments AD6412 Manual De Usuario

_______________________________________________________________________________
Meter, see Figure 3.
It shows "L0.01 ", indicating that the measured resistance value exceeded the lower limit
of Meter, see Figure 6.
In HOLD state, it is required to press HOLD key to quit the HOLD state before continuing
measuring.
Flash symbol indicates that the measured resistance value has gone beyond the
alarm critical value.
In other modes, AD6412 can be switched to the resistance measurement mode by
pressing MODE key.
In HOLD state, AD6412 is required to press SET key or POWER key to quit HOLD state;
then press MODE key to switch to the mode of resistance measurement.
In a state of alarm setting value, AD6412 needs first to press POWER key or SET key for
3 sec to quit from the state, then press MODE key to switch to the mode of resistance
measurement.

4. Current Measurement

After the booting auto-inspection is completed, the Meter automatically enter the
resistance measurement mode. Upon showing "OL ", press MODE key, and the Meter
enter the current measurement mode, showing "0.00mA" , see Figure 7. At this point,
press the trigger and open the jaws, clamp the target wire, reading to get the current
value.
It shows "OL A", indicating that the measured current value exceeded the upper limit of
Meter, see Figure 8.
Flash symbol indicates that the measured current value has gone beyond the alarm
critical value.
In other models, it can switch to the resistance measurement by pressing MODE key
mode.
In HOLD state, needs first to press SET key or POWER key to quit from HOLD state, then
press MODE key to switch to the current measurement mode.
In a state of alarm setting value, needs first to press POWER key or SET key for 3 sec to
quit from the state, then press MODE key to switch to the mode of current measurement.
©Copyright Abacanto Digital SA.
Manual de usuario AD6412
AD Instruments
37