Renishaw UCC T3 Guia De Instalacion página 23

UCC T3 installation guide
www.renishaw.com
Regenerating loads
The UCC T3 controller can be attached to motors that cause a regeneration of voltage during the deceleration stage of machine motion. The
system integrator must ensure that the power supply used in the installation will permit any regenerative voltage to be accepted without
failure.
NOTE: If the power supply is not able to withstand this regenerative voltage from the motors, then a suitable diode must be wired
in series with the positive supply to isolate this event.
Issued 04 2019
23