Using Telnet - Juniper Networks NetScreen-5GT Wireless Manual Del Usuario

Chapter 2 Configuring the Device
The NetScreen WebUI software displays the login prompt.
Note: If you choose to skip the Initial Configuration Wizard, the WebUI login
prompt automatically appears.
2. If you have not yet changed the default user name and password, enter
netscreen in both the User Name and Password fields and click Login. (Use
lowercase letters only. The User Name and Password fields are both
case-sensitive.)

Using Telnet

Telnet is an application that allows you to access devices through an Internet Protocol (IP)
network.
Note: You can also access NetScreen devices using Secure Shell (SSH) applications. For
more information, refer to the "Administration" chapter in the "Administration" volume of
the NetScreen Concepts & Examples ScreenOS Reference Guide for ScreenOS 5.0.0.
To configure the device using Telnet, you enter ScreenOS Command Line Interface (CLI)
commands in a Telnet session from your workstation.
1. Start a Telnet client application to the IP address for the Trust or wireless2
interface. For example, enter the following:
2. If you have not yet changed the default user name and password, enter
netscreen at both the login and password prompts. (Use lowercase letters
only. The login and password prompts are both case-sensitive.)
14
telnet 192.168.1.1
User's Guide