Changing The Trust Or Wireless2 Interface Address; Verifying External Connectivity; Resetting The Device To Factory Defaults - Juniper Networks NetScreen-5GT Wireless Manual Del Usuario

Changing the Trust or Wireless2 Interface Address

You can change the IP address and netmask of the Trust and wireless interfaces if
necessary. (Remember that when the Trust or wireless2 interface is in NAT mode, the IP
addresses of devices in your network are never seen by computers outside your network;
outside computers see only the IP address of the Untrust interface.) For example, you
might need to change the Trust or wireless2 interface to match the IP addresses that
already exist on your network. If you change the IP address and netmask of the Trust or
wireless2 interface, then you also need to change either the range of addresses that the
NetScreen device assigns via DHCP to devices in the network or disable the DHCP server
on the Trust or wireless2 interfaces.
If the computers in your network obtain their IP addresses from the DHCP server on the
NetScreen device, then the computers also obtain their default gateway from the
NetScreen device. If a computer has a statically assigned IP address, then you must
manually set its default gateway to the IP address of the Trust or wireless2 interface on
the NetScreen device.
To assign a different IP address and netmask to the Trust or wireless2 interface, refer to
the "Interfaces" chapter in the "Fundamentals" volume of the NetScreen Concepts &
Examples ScreenOS Reference Guide for ScreenOS 5.0.0.
To change the DHCP settings for the NetScreen device, refer to the "System Parameters"
chapter in the "Fundamentals" volume of the NetScreen Concepts & Examples ScreenOS
Reference Guide for ScreenOS 5.0.0.
V E
ERIFYING XTERNAL
To verify that workstations in your network can access resources on the Internet, start a
Web browser from any workstation in the network and enter the following URL:
www.juniper.net.
R
ESETTING THE
If you lose the admin password, you can reset the NetScreen device to its default settings.
This destroys any existing configurations but restores access to the device.
Warning: Resetting the device deletes all existing configuration settings and renders
existing firewall and VPN service inoperative.
You can restore the device to its default settings in one of the following ways:
• Using a Console connection. For further information, see the "Administration"
chapter in the "Administration" volume of the NetScreen Concepts & Examples
ScreenOS Reference Guide for ScreenOS 5.0.0.
• Using the reset pinhole on the rear panel of the device, as described in the next
section.
NetScreen-5GT Wireless
C
ONNECTIVITY
D F
EVICE TO ACTORY

Verifying External Connectivity

D
EFAULTS
29