Changing The Port Mode - Juniper Networks NetScreen-5GT Wireless Manual Del Usuario

Chapter 2 Configuring the Device

Changing the Port Mode

The port mode is the binding of physical ports, logical interfaces, and zones.
Warning: Changing the port mode removes any existing configurations on the NetScreen
device. Therefore, you should change the port mode before you configure the device.
The following table summarizes the port, interface, and zone bindings for the port modes
that are available on the NetScreen-5GT Wireless devices:
Port
Trust-Untrust Port
a
Name
b
Mode
Interface Zone
1 trust Trust
2 trust Trust
3 trust Trust
4 trust Trust
Untrusted untrust Untrust
c
Modem serial Null
wireless1 Wzone1
wireless2 Trust
a. As labeled on the NetScreen appliance chassis.
b. Default port mode.
c. You can configure a backup interface to the Untrust zone using the Modem port. See
Zone Interface" on page
26
Home-Work Port Trust/Untrust/DMZ
Mode (Extended) Mode
Interface Zone Interface
ethernet1 Work ethernet1
ethernet1 Work ethernet1
ethernet2 Home ethernet2
ethernet2 Home ethernet2
ethernet3 Untrust ethernet3
serial Null serial
wireless1 Wzone1 wireless1
wireless2 Work wireless2
wireless3 Home wireless3
wireless4
28.
Dual Untrust Port
Mode
Zone Interface Zone
Trust ethernet1 Trust
Trust ethernet1 Trust
DMZ ethernet1 Trust
DMZ ethernet2 Untrust
Untrust ethernet3 Untrust
Null serial Null
Wzone1 wireless1 Wzone1
Trust wireless2 Trust
DMZ
Wzone2
"Configuring a Backup Untrust
Combined Port
Mode
Interface Zone
ethernet1 Work
ethernet2 Home
ethernet2 Home
ethernet3 Untrust
untrust Untrust
serial Null
wireless1 Wzone1
wireless2 Work
wireless3 Home
User's Guide