Olsberg Ipala Smart Compact 23/785 Manual De Instrucciones página 21

 Decide where the stove is to be installed. There must
be no objects made of combustible materials within a
distance of 80 cm of the stove's radiation area,
measured from the combustion chamber's inspection
glass, nor may any be placed within this area
subsequently.
Depending on the installation position of the stove in
front of walls that need to be protected (flammable or
load-bearing), the following distances from walls need
to be observed in accordance with the position of the
combustion chamber door to the wall / side panel or
the back panel (see schematic diagram).
For building walls and ceilings to be protected with a
U-value <0.4 W / m²K, the specified minimum
distance to these components must be increased by
5 cm.
When not dealing with walls that need to be
protected, you merely need to observe a minimum
distance of approx. 5 cm to allow for proper heat
dissipation.
 Install the pipe lining (provided on site) in the
chimney. The connection height can be individually
specified for a top stovepipe connection, however
should not exceed 1.5 m from the connector sleeve.
For the rear stovepipe connection heights please
refer the "Technical Data" chapter. No combustible
material is permitted within a radius of 20 cm around
the stove pipe.
 Connect the stovepipe at both connection points with
stove putty so that the stove pipe is permanently
sealed.
 Push the stove onto its planned position and orient it
so that the stovepipe fits into the pipe lining.
The stovepipe connections must be tight. The stove-
pipe must not protrude into the chimney.
Bear in mind that on partition walls in accordance
with test specification EN 13240 the temperature of
85°C can be reached, and with light wallpaper or
similar combustible construction materials this can
result in colour changes.
21