Grouw 18184 Manual De Instrucciones página 72

Fit the side plate and blade by screwing the
lock nuts tight by hand while lifting the end
of the blade upwards.
Turn the chain tensioner screw until the
chain's drive link touches the underside of
the blade.
Tighten the nuts securely and tension the
chain fully while holding the end of the blade
upwards.
Tightening the chain
Adjust the chain tension by turning the chain
tensioner screw (7).
Turn the screw clockwise to tighten the chain
and anticlockwise to slacken it.
There should be a few millimetres of play in
the chain when lifted from the centre of the
blade. The chain must not hang below the
blade.
Note! A new chain expands initially. It is
therefore important that the chain tension
is checked often during the saw's fi rst few
hours of use. Manually lubricate the chain
regularly using chain oil.
Note! Loosen the lock nuts before adjusting
the chain tensioner, otherwise the parts may
be damaged.
72
Store the key by clicking it securely into the
holder (9) on the chainsaw.
Filling with fuel
Remove the cover (19) from the fuel tank
and fi ll with fuel (a mix of suitable two-stroke
oil and lead-free petrol at a ratio of 1:40).
Replace the cover and check that it is tightly
sealed.
Filling the chain oil
Remove the cover (21) for the chain oil tank
and fi ll with fresh chain oil. Replace the cover
and check that it is tightly sealed.