Grouw 18184 Manual De Instrucciones página 74

Press the primer (11) 10 times until fuel is
visible in it.
Pull the starter handle (20) until the engine is
about to start, but no more than 5 times.
Push the choke in.
Pull the starter handle until the engine starts.
Allow the engine to warm up for 30 seconds.
Deactivate the chain brake.
Press the throttle (17) and the safety switch
(13) in to use the chainsaw.
Be aware that the chain moves around once
you rev up the engine!
The chain must not move around when
the engine idles. If it does, adjust the idling
speed as described under Carburettor
adjustment in the Maintenance section.
Starting a warm engine
The warm engine start procedure is the same
as for cold, except that you do not need to
pull the choke out.
Stopping the engine
Release the throttle and allow the engine to
idle for a couple of minutes.
Push the on/off button down to the "O"
position.
74
Running in the engine
The engine should be run in for the fi rst 20
operating hours. Avoid running at full revs or
at high speed for prolonged periods in the
fi rst 20 operating hours.
Automatic chain lubrication
You can adjust the lubrication using the
adjustment screw on the underside of the
saw.
Start the chainsaw and point the blade down
towards a tree stump or similar. If an oil stain
appears on the tree stump, the automatic
chain lubrication is functioning correctly. If it
is not, remove the chain and blade and clean
the oil feed hole. If this does not help, take
the saw to an authorised repair shop.