Maintenance Maintenance And Inspection - Hitachi N 3804AB3 S Instrucciones Y Manual De Seguridad

NOTE:
The information contained in this Manual is designed to assist you in the safe maintenance of the Stapler.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Stapler.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 8).
● Disconnect air hose and remove all staples
from Stapler when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed staple in the following order:
1 Disconnect air hose.
2 Remove all staples.
3 Release the lock lever and open guide plate.
3
Lock lever
3
Guide plate
4 Remove the jammed staple with a slotted-head
screwdriver.
Guide plate
5 Close guide plate and latch.
6 In case of frequent jam, contact a Hitachi
authorized service center.
MAINTENANCE
WARNING
Disconnect
1
air hose
2. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
○ Do not store the Stapler in a cold weather
environment.
Keep the Stapler in a warm area.
○ When not in use, the Stapler should be stored in a
warm and dry place.
Keep out of reach of children.
3. WARNING LABEL
Do not use the Stapler with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a Hitachi
authorized service center.
4. Maintenance chart (See page 21)
5. Operator troubleshooting (See page 21)
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
● Repair, modifi cation and inspection of Hitachi
Power Tools must be carried out by an Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with
the tool to the Hitachi Authorized Service Center
when requesting repair or other maintenance. In
the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
English
Warning label
19