Infra Red Remote Control; Manual Operation - ClickTronic 60810 Manual Del Usuario

5.4.2 Infra Red Remote Control:

• There are separate
ON/OFF buttons for
each output A and B
and 4 separate selector
buttons for the
source device.
Output A:
• Use the ON/OFF button of output A for star-
ting transmitting the signals to output A. The
LED indication (Active A) at the front side of
the housing flashes on. By pushing this button
again, the switches to standby mode.
• Use the key buttons for choosing between the
source devices.
Output B:
• Use the ON/OFF button of output B for star-
ting transmitting signals to output B. The indi-
cation LED at the front side of the housing
(Active B) will flash on. By pushing this button
again, the Full HD Matrix switches to standby
mode.
• Use the key buttons for choosing between the
source devices.
Resetting:
• Use the RESET button on the remote control to
set the Full HD Matrix into initial condition.

5.4.3 Manual Operation:

• The outputs A and B have seperated selection
buttons for the source devices and
for switching the product ON and OFF.
Output A:
• The SELECT/POWER button is a multifunctio-
nal button.
• Activating: Push the SELECT/POWER button
for 2 seconds to switch off the Full HD Matrix.
(standby mode).
• Push it again for 2 seconds to restart the pro-
duct.
• Selecting the source device: If you would like
to choose the input channel manually, push
the SELECT/POWER button again for 1 second.
A green LED will flash on to identify the active
channel
Output B:
• The SELECT/POWER button is a multifunctio-
nal button.
• Activating: Push the SELECT/POWER button
for 2 seconds to switch off the Full HD Matrix.
(standby mode).
• Push it again for 2 seconds to restart the pro-
duct.
• Selecting the source device: If you would like
to choose the input channel manually, push
the SELECT/POWER button again for 1 second.
A green LED will flash on to identify the active
channel.
18 Clicktronic®